Nano Infiltration Waterproof Agent

Product advantages

1. This product is non-toxic, odorless, non-polluting, non-corrosive, convenient and quick to construct, and suitable for a variety of base surfaces Construction on the wall;

2. It has good moisture-proof, anti-corrosion, anti-pollution, anti-salt precipitation and anti-weathering (anti-aging of the wall) to maintain the original color The function plays a protective role on the wall;

3. With strong permeability, waterproof and breathable, after spraying (painting) to form a waterproof film, rain or moisture cannot penetrate into the moisture inside the wall, but the moisture inside the wall can still be radiated out without obstacles through the waterproof film, achieving the function of being waterproof and breathable;

The scope of application

1. Moisture-proof, anti-leakage and anti-pollution of the wall finishes of various buildings;

2. Moisture protection for gardens , stone carvings , ancient building protection warehouses , cemeteries , granaries , archives , museums , etc;

3. Salting out of tiles , mosaics , marble , granite , etc;

Construction technology

1) there  must  be  no  looseness ,  oily  material ,  and  cement  mortar  if  there  are cracks . The base surface must be dry during construction .

2) Spraying or brushing: Use a clean agricultural sprayer or roller brush on the dry base  surface  (wall  surface ,  etc . )  continuously for 2-3 times vertically and horizontally, without intermittent ;

3) Add cement mortar to use: waterproof agent and water in a ratio of 1 :1 to 3 , then add cement and sand to  mix the slurry for use , and  moisten the  base surface before use;

Matters needing attention

1. Rainwater shall not be invaded within 24 hours after construction, and the construction shall be stopped if the temperature is below 4℃ , and the base  surface must be dry during construction;

2. It is not suitable to use this product on impermeable base surface. If it is sprayed too much, white crystals will form on the surface;

3. It is not recommended to mix conventional materials with water. The concentrated stock solution must be mixed with water at a ratio of 1:5-8 between the material and the water;