Kitchen and Bathroom Waterproof King

Product advantages

1. The construction is convenient, and it can be constructed on the wet base surface;   the adhesion is strong, the strength is high, and the tiles can be directly pasted on the waterproof layer, never hollowing or falling bricks;

2.Super strong anti-pressure and anti-seepage ability, no dripping; used on the front or back surface, its waterproof effect remains unchanged;

3. It is environmentally friendly, non-toxic and harmless, and it is the nationally recommended waterproof material for home improvement；

The scope of application

1.It is most suitable for the waterproof and moisture-proof treatment of kitchen and bathroom, and can be used for waterproofing of ground, balcony and other projects;

2. It can also be used for waterproofing of buildings with stable structures such as factory buildings, water conservancy projects, grain warehouses, tunnels, underground parking lots, swimming pools, drinking water pools, etc;

Construction technology

1. Base preparation

(1) The substrate must be firm, flat, clean, free of dust, greasy, wax, release agent, etc. and other debris;

(2) All small pores and sand holes can be mixed into a wet mass with the plugging king and a little water, and then smoothed;

(3) Before applying the slurry, fully moisten the substrate in advance, but there should be no stagnant water.

2.Use a brush or rolling brush to directly apply the slurry on the base surface, and check carefully for any missing brushes or defects. Intermittent stirring should be  maintained during operation to prevent precipitation.

3.For moisture-proof, one layer can be applied; for waterproof, at least two layers should be applied. The multi-layer construction method should be adopted, and the standard amount should be used for construction, and the thickness of a single layer should not exceed 1mm.

4. After the first layer is completely dry (about 2-4 hours), apply the second layer. The brushing direction of the second layer should be perpendicular to the brushing direction of the first layer. It is forbidden to step on within 24 hours after construction, and make a protective layer after the waterproof layer has dried.

Matters needing attention

1.This product is suitable for use in an environment of 5℃ ~ 35℃ , and must be protected from rain, hot sunlight and frost during the construction process.

2.The slurry should be used up within 2 hours after the adjustment. Do not mix the dried slurry with water before using it.

3. After the waterproof layer is completely dried, other covering layers can be used.